Инфо за ДДЕ5

[cgm Профил ICQ]

Здравейте колеги,
попаднах на интересна информация за компа ДДЕ5:

http://wiki.bavariantechnic.com/index.p ... 7#Commands


DDE50K47

BMW Digital Diesel electronics 5.0 for M47
Communications

DDE50K47 uses the KWP-2000* over K-line at 9600 protocol and is located at bus address 0x12
Supported Features

Identification
Information
Fault Codes
Erase Fault Codes
Actual Values
Activations
Commands
Activations
DDE50K47 supports the following activations:
Blower Fan 10%
Warning: The elektric blower fan can only activated between 10 and 90%, it takes a few seconds until the fan is at the requested speed
Blower Fan 20%
Blower Fan 30%
Blower Fan 40%
Blower Fan 50%
Blower Fan 60%
Blower Fan 70%
Blower Fan 80%
Blower Fan 90%
Blower Fan off
Fuel pump relay on
Fuel pump relay off
Glow plug relay on
Glow plug relay off
Electric heater 10%
Warning: The elektric heater can only activated between 10 and 90%
Electric heater 20%
Electric heater 30%
Electric heater 40%
Electric heater 50%
Electric heater 60%
Electric heater 70%
Electric heater 80%
Electric heater 90%
Electric heater off
Boost control valve 10%
Warning: The Boost control valve can only activated between 10 and 90%
Boost control valve 20%
Boost control valve 30%
Boost control valve 40%
Boost control valve 50%
Boost control valve 60%
Boost control valve 70%
Boost control valve 80%
Boost control valve 90%
Boost control valve off
Exhaust Recirculation valve 10%
Warning: The EGR valve can only activated between 10 and 90%
Exhaust Recirculation valve 20%
Exhaust Recirculation valve 30%
Exhaust Recirculation valve 40%
Exhaust Recirculation valve 50%
Exhaust Recirculation valve 60%
Exhaust Recirculation valve 70%
Exhaust Recirculation valve 80%
Exhaust Recirculation valve 90%
Exhaust Recirculation valve off
Swirl valves on
Swirl valves off
Commands
DDE50K47 supports the following commands:
Idle rpm default setting
Warning: Idle can only be changed between -20 and +50 RPM. Execute only when engine is warm and deactivate airconditioning and other electrical loads
-10 RPM
-20 RPM
+ 10 RPM
+ 20 RPM
+ 30 RPM
+ 40 RPM
+ 50 RPM
Basic settings Exhaust-gas recirculation
Warning: EGR adjustmentment is performed in 10mg/stroke steps. Limits: + 40mg/stroke and - 40mg/stroke. Execute only when engine is warm and deactivate airconditioning and other electrical loads
Rise air-mass + 10mg/stroke
Rise air-mass + 20mg/stroke
Rise air-mass + 30mg/stroke
Rise air-mass + 40mg/stroke
Lower air-mass - 10mg/stroke
Lower air-mass - 20mg/stroke
Lower air-mass - 30mg/stroke
Lower air-mass - 40mg/stroke
Basic settings start quantity
Warning: start quantity adjustment. Engine must be OFF and ignition ON. Starting quantity is increased in 1mg/stroke steps. Reduction from 0 to -1 mg/stroke is not possible. Minimum value: 0mg/stroke. Maximum value: 7mg/stroke
start quantity + 1mg/stroke
start quantity + 2mg/stroke
start quantity + 3mg/stroke
start quantity + 4mg/stroke
start quantity + 5mg/stroke
start quantity + 6mg/stroke
start quantity + 7mg/stroke
HFM Reset idle adaption
Warning: Adaption is only possible when idling or at ignition on
HFM Reset load adaption
Warning: Adaption is only possible when idling or at ignition on
Please refer to the commands page for detailed info.